System II incorporates our 92145 4 1/4" O.C. snap tape
and 93140-93143 spaced front-load carriers. These
draperies are fabricated using the charts in the Kirsch
Fabrication Guides. Flat panels are fabricated to the
designated hemmed fabric width. Master and return
snaps are attached to a length of snap tape measured to
fit the fabric width. The tape is then sewn onto the flat
panel. This snap tape is then ready to snap onto the snap
pendants, and then into teh spaced front-load carriers

Snap Tape 92145

• Tpae is 7/8" wide, with snaps 4 1/4" on center
• Snaps are nckel-plated brass. They are resistant
  to corrosion and rust, and can be washed or dry-cleaned.
• Tape can be washed or dry-cleaned. Shrink factor is less than 3 percent

• Carriers aremolded of Celcon, a high-tech grade of ultra-high density stabilized plastic that is durable and heat resistant.
• Carriers are self-lubricating
• Carriers are spaced by molding an 80# test nylon line into the top of the carrier
• Two-piece construction allows pendant to swivel adn prevents tangling of the nylon line.
• Fullness options: 60, 80, 100, and 120 percent.